R0m102 Rev103

[Hunter 1949]

Ive been using Nagra Master V1.2(BETA), to try and unlock my card........ Ive turned the POT, down to where it stops, then up a little till I would get a good response........ But in the read me, it said it should look like this N+++N+++n+++, and so on !!!!!! But on mine I only get N+---N+---N+---........ Whats with that stuff ???????????????
Useing a T911 Moded Unlocker.
Flashed with Newd 13........

[sukh77]

Pull the board out and hold it in your hand. While the program is running the script touch various spots to see if you get different results. I would try putting finger on the dip switch. I had a problem there and lots of other people had problems with there T911. There is another thread. Search my posts.

[Hunter 1949]

Is there somthing else I should do to the card, if the program just keeps, running and running..... Never seems to unlock it...........

[sukh77]

You can try the winexplorer script. That's what most people used. The scripts are available in the public files section.

[Hunter 1949]

Great news........ I went to Radio Shack and got a ( 25 ohm ) reostat trim pot, to replace the pot, that come with the loader..... Took about three minutes, and it poped......... Part number.. 271-265.........

Thanks for all the help, from everyone........:D