cemu101.5 giving error 019

[rubberman]

use the Cemu101.5 boot disk creator. flashed my 1 chip with the flash from the cemu101.5 file in the files section. use flashedit to edit the tsop to match the public ones. WHEn cemu101 boots up, the last line shows ATR string but also says 'not sending ATR' which i also get the 'card not inserted correctly'. the SYS INFO shows nothing where the 'DISH500 ready' or the camID. so its a communication issue between the ird and computer. i know i have this wired up good. any other ideas?

www.dssftp.com/forum/attachment.php?attachmentid=4121&d1101861594
this is the 1 chip i went by

[Jackolantern]

CEMU shouldn't be sending an ATR. The Flash on the atmel should do that and so 'noatr 1' is in the ini file.
but what the hell do I know...I have the same problem as you with a 2 chip max/mel

------back ot reading---if I find anything I will post

Jack

[seaboard18]

Seems to work fine using rom 10. I have not had time to try it with the rom 101. There were some modifications that need to be made. I saw more than one flash for the max/mel over at rom10x. Make sure you have the correct one installed.

***Extract all files to c: drive. Or change the path in the bat file to reflect the file locations.

1. Flash your receiver with unmodded tsop flash.
2. Make sure firmware is upgraded to latest version for your receiver.
3. Change Box Keys and Ird in flash edit to these

For BEV
Ird:R 00 4502 4458
Box:FD BF 2E 56 AF FA 72 64

For DISH
Ird:R 00 1864 2028
Box:8C A6 A8 8C FD E2 E2 63

5. Fix Checksum and save flashedit file.
6. Write Flash to receiver.
7. Run Dish Emulation.bat file and choose provider.

Both provider files are working as of 1-26-06.

[cancom]

Absolutely excellent post Seaboard18!!!!

I've had numerous queries for, "why won't my system run 101.5?"
Yes, all please note that for cemu101.5, you can't just build a cemu file and go.
The modded TSOP flash must be changed accordingly:

For BEV
Ird:R 00 4502 4458
Box:FD BF 2E 56 AF FA 72 64

For DISH
Ird:R 00 1864 2028
Box:8C A6 A8 8C FD E2 E2 63



cancom

[locash]

use the Cemu101.5 boot disk creator. flashed my 1 chip with the flash from the cemu101.5 file in the files section. use flashedit to edit the tsop to match the public ones. WHEn cemu101 boots up, the last line shows ATR string but also says 'not sending ATR' which i also get the 'card not inserted correctly'. the SYS INFO shows nothing where the 'DISH500 ready' or the camID. so its a communication issue between the ird and computer. i know i have this wired up good. any other ideas?

www.dssftp.com/forum/attachment.php?attachmentid=4121&d1101861594
this is the 1 chip i went by

Had the same prob... wired the chip wrong.

Maybe this will clear up where the connections go, using under side of smartcard as ref point.