badman08
01-28-2006, 11:15 PM
After 1 week trying to flash 911 loader(5k spot trimmer). It seem unable to open it.
Can someone help to fix this problem:
-I setup driver like this: On post setting: bits per second:11520-data bits:8-parity:non-stop bit:1-flow control:X/on,X/off
-connect the loaded with 300mA AC-DC Adapter at 9 and usb to serial cable at com 2
-Using newd13 with XpAtmel
-pin 1 and 5 on
Hopefully my setup was right
After click on the program it give me the notice: Hex file loaded-Failed:cannot open dynamic driver
My question is: can i use usb to serial cable for this loader and do i need put the card(rom102)into loader when i do flash.
Another way to flash loader i used ufp16 software and after click on connect button it seem connecting forever.
thanks for advance
Can someone help to fix this problem:
-I setup driver like this: On post setting: bits per second:11520-data bits:8-parity:non-stop bit:1-flow control:X/on,X/off
-connect the loaded with 300mA AC-DC Adapter at 9 and usb to serial cable at com 2
-Using newd13 with XpAtmel
-pin 1 and 5 on
Hopefully my setup was right
After click on the program it give me the notice: Hex file loaded-Failed:cannot open dynamic driver
My question is: can i use usb to serial cable for this loader and do i need put the card(rom102)into loader when i do flash.
Another way to flash loader i used ufp16 software and after click on connect button it seem connecting forever.
thanks for advance