301.013 programming problem

[jakey]

I was wondering if someone can tell me what i am doing wrong? I have a 301.013 1tsop ird.I have doe a vid mod and can erase and write to it no problem.My problem is when i program a modded tsop for a rom 10 and an eeprom the same as my ird build i can't get a picture.I get 101 and the preview channel and all the channels are listed in the guide but the screen is blank.The firmware of the tsop is 209.Can any one help me?

[mad max]

I don`t know for sure because mine are set not to take updates but when I did them I used p207 sw they wouldn`t work on p209

[jakey]

I have a 301.013 working with a rom 10. I downloaded the tsop and eeprom and wrote them to the new ird and still no picture. both are at 208 firmware. Any help or insight would be appreciated.

[crystal368]

jakey:

running fine here with a 013 at p209 using a modified daha tsop & dahd eeprom with an all-in-one bin, all three from another site. clean card as usual apply bin & do the usual with jkeys for tsop & eeprom, assuming vid-mod is good to go. when looking at the tsop with jkeys/flashedit some info will be f`d out. just apply as is. worked for me.

pm me for files.

crystal368

[dishman84]

Check Your Rsa Keys, Sounds Like The Keys Are Wrong. Dont Take Any Updates.

[jakey]

I have tried several downloaded modded tsop of different builds and the same result.I have used DANA DAHA DALA and still no luck.How can I ck the RSA keys?

[crystal368]

jakey:

i had same problems when i was trying to mod my own tsop & apply individual patches to my rom 10. what worked for me was a pre-moded all-in-one bin, just start with a clean card at correct rev write bin. done.

same with tsop. thoroughly erased tsop wrote pre-moded p209 tsop. even though when looking at tsop in flashedit/jkeys some info is f`d out just apply as is.

sounds like you are using pre-moded tsops and patching/programming your card on your own. have you tried a pre-moded bin?

[bobcon]

Make sure your tiers have not expired and that you are using the right keys. A lot of the files you down load with the updates are not correct look at the dates and the keys before you run the patch and dont forget to write a vigin card image back to the card before programing it

[jakey]

I don't have a problem with the card as it is working very well in another 301.013.I think my problem is with the tsop and eeproom of the ird that I can't get to work.Yes i am using a modded tsop and am using all in one patch.

[jakey]

Make sure your tiers have not expired and that you are using the right keys. A lot of the files you down load with the updates are not correct look at the dates and the keys before you run the patch and dont forget to write a vigin card image back to the card before programing it Are you saying that i should be using a virgin eeproom with the modded tsop.