A bunch of new FTA receivers for peanuts and AVR-X program update on Wednesday

[mili]

I got a bunch of Digiwave receivers in stock for very low prices. I also have all the LNBs, motors and Dishes you need for an FTA setup. Check out https://dssftp.com/xcart/home.php?cat=11 for the receivers.
On another note, the AVR-X man is back and says to expect 1.0.8 update fixing blackouts and BEV autoroll by this Wednesday. Translated to English that means sometime next Monday or later.

[mclush]

mili i was wondering if the new 1.08 fix will fix the s00000 on cam id because i was up and going on bell 2700 avrx and now after reprograming i am stuck on aquiring sat signal and card reads s0000000 all other # are ok

[mili]

Man I wish I could say yes but until we see the program and test it I have no answer either way :(

mili

[nags]

Is he actually going to fix the 301-010 "019" problem. There are a lot of us that are waiting patiently for the avr-x to perform properly on these receivers. Just so you know I have had absolutely no luck in getting my AVR-X card to work. Did just about everything that was suggested in other threads on this subject and nothing has worked. Tried avr-x 1.05, avr-x 1.06, avr-x 1.07. No luck.

Old magic card brings the receiver up and I can access the menues so I don't think it is the receiver. Software on the receiver is P243. Jkeys works on this receiver without any problems. Loaded flashes, saved flashes, checked them with a Hex editor and they match perfectly so again, I don't think it is the receiver.

[Doc]

mclush

Just a thought but did you try running 1.07 using different receiver settings?? Cause I use a 4900 receiver and if you put it on the default setting, nothing happens, just 019. But if you set it for the 4900 receiver WALLA. Justr a thought

Doc

[nags]

The 301-010 has a separate plug on the card for connecting the jtag, i.e., it is the connector to the right, so I have stuck with that connector for now. I pick 301-010 model in the software for the same reason. I am afraid to start screwing around with these connections until we get more feedback on these 301-010 receivers.

[OkeeDokee]

Nags..

I have a 3100.010 never worked on the 301 pins, put it on All Models Pins works fine its on Bell Exp...