301.13 jtag erroe

[gold]

I have a 301.13 single Tsop i saved the image but now when i go to right new bin it gives me an error reading from ird (DCU PEEK) and then it says could not initiate access.Am i missing something..any help thanks..
aslo have a 2800 tryed erasing the tsop but when i go to wright to it it starts from the middle like its not fully erased..any help thanks

[HILLBILLY]

I have a 301.13 single Tsop i saved the image but now when i go to right new bin it gives me an error reading from ird (DCU PEEK) and then it says could not initiate access.Am i missing something..any help thanks..
aslo have a 2800 tryed erasing the tsop but when i go to wright to it it starts from the middle like its not fully erased..any help thanks
the dcu is because u need to ground r79, or pad 1. should solve problem.
hillbilly

[gold]

OK got ride f the error and grounded r79 but when i erase and go to wright new bin it checks if flash is erased but says its not blank....any help thanks

[HILLBILLY]

OK got ride f the error and grounded r79 but when i erase and go to wright new bin it checks if flash is erased but says its not blank....any help thanks
sounds like vid mod not on when u r doing it. needs to be on for write and erase. when u turn it on or off, make sure its not plugged into power
hillbilly

[boricua]

what power on the wall or the suppli

[HILLBILLY]

what power on the wall or the suppli
yes wall power. unplug it when u turn on or off the vidmod.