301.13,Gopherx's 42 & how do you get it togeather?

[snakebite1]

I know this is going to be a newb question but here it goes.

I have a exsub'd 102Rev103 w/301.13 dual tsop, married unit.
Software vers. is P200DATD

I unlocked the card no problem.
Cleaned codespace (Think I screwed up this part, it was supposed to be done after getting image...correct?)
Saved image.

I looked on my card and there is no DT08. Which is why I would use Gendt08...right?

But this is where I am a bit lost. Do I use Dt Tier on my card image. Use Gopherx's 42 or is there something else? I believe after all that I am to use the Rom102-V22 OR V22SK Blocker with password. Thats all correct right?

Next question would be how do I make the patch with all of that? What prog do I use to make the patch? :eek: :eek: :eek:

I have read all over the forum and now I just need a bit of conformation.

Thanks all!

[Dave411]

The hardest part of the job is unlocking the card and that is done. You have no DT08 because the 013 uses SKs. Don`t need a DT08, you are all set. Just add the tiers and make sure all the expire dates are good. Add the V22 blocker, NOT the V22SK blocker, write the card, and your done. No TSOP mod needed, your card is already married to the receiver and its SKs.

[snakebite1]

Thanks Dave411!!

Okay...so how do I add the V22 Blocker then? All I have is the text file for it.
Would I use RomExplorer to change the values?

[Littlebear151]

I find this to be a very good question in that snakebite said he clean the code space..Just wondering what cleanning the code space cleans with these new programs.. does the card still retain sub status.. or would sub info be needed to be reapplied to the card along with tiers, dates, ppv, time zone, locals, and blackout bits

should the card be cleaned to do this?

I have been wanting to re-activate a card.. I have used other methods but the clean code space was something I was wondering about..

LB

[skinerd]

I am not a card guy, but I have a 510 working without even so much as jtagging it.
All info obtained from the ex-sub card, was able to transfer keys to gopherx's 42 tier bin and then remap locals and add a blocker.....it's all done in logical steps, so I did not have to know how, just work thru it logically.

[Littlebear151]

I understand what you did but you saved the bin and then trasfered the needed info to the gopher script doing it this way you could clean the card for sure.. but he said that he clean the code space right off the batt.. I guess I could do this and then read the bin to see what was left after the clean.. just thought soneone had already done it..

LB

[Dave411]

Thanks Dave411!!

Okay...so how do I add the V22 Blocker then? All I have is the text file for it.
Would I use RomExplorer to change the values?

You use nedit7 to add the blocker. After you open nedit7, click on tools, apply patch, then copy & paste the V22 blocker, apply patch to bin, write to card. Cleaning card should not remove any of the actual sub info. Good luck.

[Littlebear151]

Thanks Dave,



LB