Bev Rom 102 rev 240 Question

[darkmoon]

I have a Bev rom102 rev 240 card , the orther card I had is now at unknown provider ,both are for Bell on 3100 so the question I have is ( don't want to screw up the good card.
1. Is n2edit 7 or nagramaster better for writing the cards?
2. If you have to redo the card do you need to put a clean image on it ?
3. Have read briefly that if a card is at rev 241 to start , & is wrote to with a blocker it will still update , any one know for sure?
4. What clean image would you put on a bev rom 102 rev 241 if you did use it in IRD ?

Thanks
darkmoon

[toad]

I have a Bev rom102 rev 240 card , the orther card I had is now at unknown provider ,both are for Bell on 3100 so the question I have is ( don't want to screw up the good card.
1. Is n2edit 7 or nagramaster better for writing the cards?
2. If you have to redo the card do you need to put a clean image on it ?
3. Have read briefly that if a card is at rev 241 to start , & is wrote to with a blocker it will still update , any one know for sure?
4. What clean image would you put on a bev rom 102 rev 241 if you did use it in IRD ?

Thanks
darkmooniI use nagraedit 7 no problems ,but nagra edit 9 has just been released you might want to wait

[BBAD]

darkmoon an open 102 at rev241 is returned to rev 240 by using n2editv7.Reset ATR and then "clean code space" three times.Re read the card and should read as rev240. Info on the card.I would stick with what penga wrote. There is a lot of stuff out there however since he is one of the group that got this all going I find it is hard to argue a reason to go elsewhere; plus his stuff is proven if you do as advised by him.