need help with mikobu N2

[aposton]

I know this sounds kinda dumb,Do you flash unlooper with jumper on or off?And do you wok on card with jumper on or off? Sorry to bother you guys,but dont want to mess anything up,you know.Thanks a bunch in advance

[aposton]

Guess it must have been a really dumb question,since nobody will bother to answer.Thanks a lot

[golk75]

Jumper on for flashing.

Off for glitchin.

[Pyotr]

I know this sounds kinda dumb,Do you flash unlooper with jumper on or off?And do you wok on card with jumper on or off? Sorry to bother you guys,but dont want to mess anything up,you know.Thanks a bunch in advance
Don't have one of those.But,you really can't mess anything up.It will just tell you it can't find the Atmel or similar. What type of card and which flash are you going to use?

[aposton]

I'm going to use a 102,and I think most are using ND13 right?

[mickeyd]

I got a new M1KOBU N2 from Mili.

Anyone know what the 9 pin (next to the power input) is for?

Also, is the power input used and if so, what to use?

Thanks

[Zim]

yes 102 with mik 3 use nd13 and about 65 ohms give or take some........

[mickeyd]

When I run Nagra Master on my new Mikobu N2, it appears to run but I never see the red LED light-up.

Is it working correctly as it never seems to pop.