2700 error programming flash

[vish0331]

I have erased the tsop (FULL) and when try to program modified tsop it give me "Error programming flash @ offset 0X7ff800ce. ALso another error pops up the Flash codes returned are not recognized by Jkeys mfg/Device codes returned are FA25/2532 (JEDEC) and FA25/2532 (flash file).
I am trying this for past 2 weeks and keeps giving me the error.
THe Modified TSOP is good, it just does not let me programm the new TSOP.

[bulls4ever]

Say have u tried grounding the pad I believe is the r79 anyone else please correct me if I'm wrong

[vish0331]

How do you ground the pad and when to ground the pad? I am using a hand made jtag connected to pin 2,3,4,5,6 (soldered) and the ground is connected to the receiver case.
I have use the same connection on my fried receiver and it works fine.

[bulls4ever]

are u getting any dcu peek errors have u tried pluging and unpluging the ird when ur supposed too,or using the correct steps, believe me it sometimes happens, don't give up it has to work just be patient...good luck

[vish0331]

yes i get dcu peak error. i am following the instruction. Beleive me i have not had this problem. I have updated the TSOP many time on all receivers.
Any other suggestion

[bulls4ever]

Well let's see u can try asking the moderators they will hopefuly help u out on this issue ur having try erasing the tsop for 5 times and reprogram, try using another bin also try different point for ground, from there I can wish u good luck but don't give up I've been in the same steps...

[troyz36]

I f I remember when I did mine, that error was due to the tsop not being erased fully. This is usually caused by low battery power. When I replaced the batteries everything was fine.
Just a thought!