Nexus Newbie

[clark_ia]

Got a Blue Nexus and trying to flash it in XpAtmel (running XP ) . When XpAtmel pops up it has stuff in the window-the scripts to be flashed -I'm guessing.....Got power source set at 9v. switches 1 and six down , when I hit the program bar nothing seems to be happening, I've left it set for 15 minutes, no differance. I am looking to pop a rom10@24, and work with 101's...Can anybody help me get going with this?

[mopar611]

Open xpatmel, scroll down window until you see 11d...

Then double click on 11d...

Another window will open up telling you its erasing and programming the atmel....

Mopar

[clark_ia]

Thanks for responding Mopar, for some reason the window wasn't loading for me,and is now, might have had to much stuff running.

[firstklass]

Ok I was just having the same issue trying to flash my blue nexus.....It turns out it was a bad serial cable...I bought a new one from Radio Shack and it worked right away

[madea]

bought a new one from Radio Shack and it worked right away[/QUOTE]




i need a serial cable also what model # did u get from r shack,
thanks

[firstklass]

This is the model no. RS-232-C Cable
theres also this no. on the box 26-117B

Male DB9 to Female DB9

[clark_ia]

Trying to glitch a couple of 101's.. 009, 008 and a 007 that was open and ready to write to, I wrote a image to the card, thought it was the orginal from the card when I got it, it is now saying..

CAM Type: ROM101 Setting IFS
Provider: Unknown
Reading Card image...
Failed to read card. (Retries: 14)...

Is this card looped?

With the Glitching I have a Blue Nexus flashed with newd11, been trying to glitch with Romreader101, been trying differant conbinations of dips down and mostly getting all fff"s..Bought a Digital Multimeter from the local WallyMart and trying to check the Olhms,had voltmeter set to 200k, the lowest I could get it to go was 3.51 , while running it read -7.22...Was checking at the two solder points by the pot..This was using the default setting in winexplorer..

'VCC range variables should only be set here if VCC Analyzer is not chosen from menu -or- VCC Analyzer set incorrect values.
VCCStart = &h14 'High
VCCEnd = &h11 'Low

'Delay range
DelayStart = &h0280
DelayEnd = &h02B8

'Tries
Const TriesPerLine = 50

Can anybody give me a few ideas?..I have played with VCCStart and End but didnt get the results I was hoping for, I tried raising and lower the numbers by segemts of about 25 at a time..And can anybody explain what effects it should be having when the numbers are raised and lowered?? Thxx! ..............Was trying power at 6v and 9v

[clark_ia]

Anybody??

[kfcf]

i need some help with a nexus iso programer evry time i open xpatmel it says could not find active atmel anyone know why

[studmonkey76]

because u dont flash an iso...