Mikobu 3 modded and Newd13.exe

[bulls4ever]

I have a Mikobu 3 already that I modded, I'm trying to use Winexplorer 5.0 to try to glitch a rom 102 Rev 103 yellow card, but program is asking for the Newd13.exe flash I've downloaded it already but what do I need to flash it ? to unlooper what else do I need to do ....thanks..

[mopar611]

Downlaod XPatmel.. It will have 13d included in it.. Flash your Mikobu with your DIP switches in the loaded position. I dont know what your loader should be set at. Search for the yours.. You will have a load postion and a glitch position...

Mopar

[bulls4ever]

Hello hey but my loader does not have any dip switches it's mikobu 3 M6.2 with green case black board but does not have dip switches

[Zim]

don't need them thats why you mod

[Zim]

by the way it is what I use (mikIII) and werks great on 102's

[bulls4ever]

I've really screwed this time, I've broke pad 4 I was trying to solder to wire and boom it pinned of from circuit I think I've really f%^ it up did I ? is there some type of fix ? heated it too much,,very very dissapointed damm

[Zim]

wow....That sux dont really know if the connection is available elsewhere ( don't think so ) but in other circuits I have werked with I have been able to solder straight to the chip if there is any trace of the pin left....if you can see a bit of metal try sharpening your soldering iron to almost a needle tip and try that ...if not don't know what to tell you buddy ....may need a new hc00 or new glitcher

[baruskie]

I've had this happen to several different chips before. Use a modeling knife and scrape away the chip over top where the pin was until you see metal. Then you can put some solder on it.