atmega 301.013

[marin001]

do i have to do a vidmod on my 301.013 to use the atmega128 with it??:D

[Twostep]

As a general rule, 301.013 dual, no. Single TSOP, yes.
Why? Because you have to modify the flash, even if you run the NoRSA mod version, and you can't do that without the VidMod.

Most likely, you'll also need to ground R79 on that receiver (either on the board itself or jump the #1 pads together at the JTAG port, if your receiver has one)

[anna]

When useing Dish as the provider you will have to bypass the SK on receivers such as the 301.013 that use an SK. Your Ird will still be able to take an update after bypassing the SK, without affecting the ATmega.,,,,,,,,,,,,,,OK This is a copy paste from satvia all-and-1,,,,
>>>SK <<<< wtha's this?:o

[REBEL14]

What Is The Sk And Have Do I Bypass It

[jmf38]

read this thread.
http://www.dssftp.com/forum/t57419-satvia-n2-atmega-no-ird-mod.html
it will help

[panchocuerdas]

As a general rule, 301.013 dual, no. Single TSOP, yes.
Why? Because you have to modify the flash, even if you run the NoRSA mod version, and you can't do that without the VidMod.

Most likely, you'll also need to ground R79 on that receiver (either on the board itself or jump the #1 pads together at the JTAG port, if your receiver has one)

I have it working with firmware 207 and tomico atmega can you explain how I can updATE the firmware and avoid the vidmode nag to modify the TSOP?:confused:

[Oil_Of_Vitriol]

Just like I did. Allow it to take an update (set the menu option and turn receiver off while still plugged in. Then jkeys and save the tsop. Then use the universal 301 .fs script with flashedit and and mod the tsop. Then re-write the tsop back to the receiver.
Does the Tomico file freeze less ? If not then u should do the Satvia and forget about needing to mod tsop after updates.

[panchocuerdas]

Just like I did. Allow it to take an update (set the menu option and turn receiver off while still plugged in. Then jkeys and save the tsop. Then use the universal 301 .fs script with flashedit and and mod the tsop. Then re-write the tsop back to the receiver.
Does the Tomico file freeze less ? If not then u should do the Satvia and forget about needing to mod tsop after updates.

The Tsop I have right now is to be used with the public tomico fix in atmega I'm on firm ware #207 do I approve to update the software as is? and then Jrag to add the modified TSOP ?? but you state I can do it without Vid Mode??
Can you confirm and explain :o

[jmf38]

yes you have to jtag and follow instructions for sat via no rsa on a 301-13.
i'm not sure how to bypass the SK on dual tsop.keep reading threads on sat via 301-13.its a good reciever-good luck