005 nag

[mickeyd]

I am trying to program a virgin Rom102 for a PVR501.

Using Dt-TierWorks v26.2 and GenDT09_SK v3.3 I can generate most of the data I need except that GenDT08 reports:

No CamID/Boxkey data type not found

Where does the Boxkey go on a Rom102 and is there anything else I need?

thanks

[Wyzzard]

You need to call and subscribe with your virgin Rom 102 and 501 receiver, after you get programming then you can add to the card. You cannot just program a Rom 102 card to work with the receiver without flashin the TSOP.

[mickeyd]

Thanks, I was afraid of that.

What about using a clean.bn102 and changing the IRD number, Boxkey, and using a Second Key? Will that work?

How long do you have to sub if that is the only way?

thanks

[Pyotr]

Thanks, I was afraid of that.
What about using a clean.bn102 and changing the IRD number, Boxkey, and using a Second Key? Will that work?
How long do you have to sub if that is the only way?
thanks

If you can fid a bin with a good DT08 on it,then you can change BK'sand ird# of your receivers TSOP to match.The public 3ms have good DT08 on them

[OverEasy]

mickeyd you could order a 102 from mili and save the image and use it in GenDT08 for all of your cards.
All of them I got from mili were xsubs but didn't have DT08 on them.

[mickeyd]

If you can fid a bin with a good DT08 on it,then you can change BK'sand ird# of your receivers TSOP to match.The public 3ms have good DT08 on them
How can you tell if it is a good DT08? Or is it just any bin with a DT08?

[fubr]

here is part of the answer for dt08

http://www.bellexpress.vu/dt08.html

[mickeyd]

Thanks for the how to, I do not have a DT08.

Guess I had better find another bin.