Failed to Read Card

[txrider]

Milli,

I just purchased one of your 811 units with the ROM102 interface card.

When I try and read the card, it fails. Here is the scenario.

I have two ISO programmers - a BlueNexus and a Mikobu. Both react the exact same way.
1. On the Nexus, I use either Switch 1 or switches 2 & 5 on.
2. The card resets just fine and returns ROM 102 REV:283
3. When I try to read the card, it fails after 20 retrys and says "Failed to Read Card"

1. On the Mikobu, the exact same thing happens. The programmer does a perfect reset, but when I try and read it I get the same error.

I have tried both N2Edit v.9 anbd NagraMaster - both yield the same results. The only difference being that with NagraMaster I get the message:

EEPROM READ FAILED. Card Locked???

Where do I go from here? I have tried various switch settings on the Nexus - 1 on only, 2 & 5 on, 4 on only.

I also have a "clean" ROM 102 at REV:105. Both programmers can read that card perfectly.

Tex

[mft1027]

I have best friend,who help me ,if I have card programming problem.Only today he help me with problem reading card.Check ,what is adapter you use for yours programmer.Same cards you can read if adapter has 6v / not 8.5v/ and center.Icouldn't read card with 8.5,but from the first time read with 6v.Maybe in yours case ,if you have 6v,change to 8v,but have to be center.Good luck.

[txrider]

I have best friend,who help me ,if I have card programming problem.Only today he help me with problem reading card.Check ,what is adapter you use for yours programmer.Same cards you can read if adapter has 6v / not 8.5v/ and center.Icouldn't read card with 8.5,but from the first time read with 6v.Maybe in yours case ,if you have 6v,change to 8v,but have to be center.Good luck.
Thanks - but I think the problem is that the unit I was sent has a locked password on it. Without that password I can not redo my tiers , etc. I am hoping Milli reads this and comes back with the password they used to lock the box.

[txrider]

Milli,
I just purchased one of your 811 units with the ROM102 interface card.
When I try and read the card, it fails. Here is the scenario.
I have two ISO programmers - a BlueNexus and a Mikobu. Both react the exact same way.
1. On the Nexus, I use either Switch 1 or switches 2 & 5 on.
2. The card resets just fine and returns ROM 102 REV:283
3. When I try to read the card, it fails after 20 retrys and says "Failed to Read Card"
1. On the Mikobu, the exact same thing happens. The programmer does a perfect reset, but when I try and read it I get the same error.
I have tried both N2Edit v.9 anbd NagraMaster - both yield the same results. The only difference being that with NagraMaster I get the message:
EEPROM READ FAILED. Card Locked???
Where do I go from here? I have tried various switch settings on the Nexus - 1 on only, 2 & 5 on, 4 on only.
I also have a "clean" ROM 102 at REV:105. Both programmers can read that card perfectly.
Tex
Update: Mili sent me a couple of other passwords to try and one of them worked to unlock the card. Problem solved....