DishNet Key roll on a few channels

[mili]

Ikey0 : AEF10F87F958E1553AE48BAEEDDBBBDF new Active
Ikey1 : C56C66893A32D0C9242BF04F03680692 Same as before now not active though

If you are missing channels redo your AVR-X with the keys above and/or enable autoroll.

mili

[BirdieMod]

New Dishnet Key 0 is now fully active all channels, Was only a few earlier.

[notsonewbie]

i had NO channels
this did the trick, thanks for coming to the rescue again milli.
you are on top of it as usual.:) :) :) :)

[Exodus]

Keys work perfectly. thanks a lot!!

[kirk6677]

I have yet to find a autorol for my fortec ultra, I am thinking it is the bad version that everyone refers to before dec 2004 or something to that nature.

I have the 282t bin and I wanted to manually change the keys, I used winhex and managed to find the old key 01 but I do not know what the old key 00 was to search for it.

Is there a easier way to fix this roblem or am I doing the ight thing?

I would assume I find the old key and change to new key save and then flash the reciver.

I used to understand everything fine until nagra 2 and now I am just lost. gues it is time to get a new reciver

[drywaller]

hi what software version should i be using on a 3100...i got dp301 p243 right at the moment with the new keys and still black screen

[Rubenator]

Programed AVR-x card using the 2.06. When I put the card in the receiver it says this card is not vailid for this receiver. Can anyone help. Thank you.