501 not receiving signal

[500 MG]

hi people,

I m not receiving signal on 501.
I flashed my receiver with no rsa fix and using atmega satvia all in 1, i followed the instructions as under:

Get a P063 TSOP from the bank.
Edit it, using Flashedit-2, with your IRD data (IRD# and Booxkeys).
Flash the modified TSOP to U7 on your IRD.
Flash a virgin P063 or P080 eeprom to it (generated by Flasedit-2).
Put the card in.
Power it up without the coax connected.
Let it run for a few minutes, that should marry it.
Then do the same process with the latest TSOP.
Let it update WITH the coax connected.
You should now be good to go.

i think i got everything right because i done it twice and getting same error "The satellite signal has been lost signal acquisition is in progress please wait or press the up or down key to change channels" and then i try to see my signal through remote control it dont let me select the Point Dish/Signal so i can not check my swith i know signal strength is good because my 301-010 is working just fine no porblem at all.

any idea what could be ?

Thanks.

[mickeyd]

What software version are you on now?

If it does not update to P308 quickly, then go to SYS Info and check the Location ID. If it is 1 then you need to clear address SA52 in TSOP2.

[500 MG]

What software version are you on now?
If it does not update to P308 quickly, then go to SYS Info and check the Location ID. If it is 1 then you need to clear address SA52 in TSOP2.
the location ID is good its not 1, but the software is not updated to P308 still on P063.

[Darkbob]

I don't think it will update from P063 to P309 (current). You will probably need to erase SA52 in Tsop2 and restream. Or get a new tsop from the tsop bank.