Emulator Board used as a Passive Interface

[crackmaster]

I have a emulator board\card that I once wanted to use for Direct TV HU card emulation. Could this same board\card be used as a Passive interface card for a cardless dish receiver(311, 811). It has a RJ45 card connection on it. If so would any one have the pinouts or colour codes(WB, B, etc) where the individual UTP wires would go on the receiver(311, 811).

[traylehr]

I was looking into this, & i believe its possible w/modifications. Also if you were wanting to use it to prog. the 311 i believe it is also possible, milli has the wireing diag. on his bev site, you can look there.