converted

[RavesRus]

ok i just remodded a 3900 from a 2800 back to a 3900.

My system info is

3900 Upgraded
R @#$!@#$!#-33
S 0000000000-00
Dnasp 102 Rev 240
Soft Version P231
Location id 00000001

Im just getting ready to point back to dish. Im planning on running atmega.
Im not sure what my next step is.

Should i flash sa30 and force an update, then re-mod the ird for atmega?

ant help greatly appreciated

[boobookitty]

Youve been ecmed loc id 00000001 means you need to flash secteor not sure witch one but read up one of the mods leave at the bottom of avtar.

[fubr]

What did you do to get it location 000001?
did it say that soon as you flashed i9t or did you put it in the stream and it poped up a box that said errer 153 a serious problem has been detected?

This is interesting it it did.

here is what to erase or either flash the whole box with a good tsop

2700/2800/3700---------------->SA5
3800/3900/4700/4800/4900----->SA30
301.10/3100------------------->SA3(flash1)
301.13(single tsop)------------->SA49
301.13(dual tsop)-------------->SA15(flash2)
501/5100/508/5800/510-------->SA60 & SA62(flash2)
6000-------------------------->SA30(flash1)

[Pyotr]

ok i just remodded a 3900 from a 2800 back to a 3900.
My system info is
3900 Upgraded
R @#$!@#$!#-33
S 0000000000-00
Dnasp 102 Rev 240
Soft Version P231
Location id 00000001
Im just getting ready to point back to dish. Im planning on running atmega.
Im not sure what my next step is.
Should i flash sa30 and force an update, then re-mod the ird for atmega?
ant help greatly appreciated

Did you know that the 3900 has a 2 meg tsop and the 2800 has a 512k tsop?Your problem might have something to do with the mismatch in tsop sizes.