flash
05-23-2006, 08:26 AM
Trying to use a CS5000 and D*** receiver together with a DP44 switch. I have a dual dc-pass splitter installed after the power inserter with the outputs going to both receivers. The D*** receiver works fine with this configuration, but the CS5000 will not switch satellites. If I disconnect the other receiver from the splitter then the CS5000 will work just fine, as soon as I connect the other receiver backup to the other output of the splitter, the CS5000 will not switch.
Anyone have a similar setup that can give me ideas on what I should do?
Anyone have a similar setup that can give me ideas on what I should do?