bluize
05-26-2006, 04:06 AM
Folks:
I am looking for some assistance with a solder style Jtag and my Bev 3100 IRD. The Jtag is a generic I bought from a guy but it came with no instructions as to what wires to solder to which pads on my IRD. The unit had a 10 wire cable with the following outputs for wires:
TCK
TDO
TMS
VDD
TDI
Vref
TRST
nRST
as well as 2 grounds.
I have searched thru the forums looking for a "map" as to where to solder what wire and have actually found 2 versions which actually contradict each other and therefore I come to this community for help. My IRD has eight pads in which I can solder to but I know from using my broken pogo Jtag that I only need five. the pictures I found dont show which way they are looking at the IRD from ...front or back so I cannot determine which is correct....any help would be greatly appreciated. thanks in advance for your time
Bluize
I am looking for some assistance with a solder style Jtag and my Bev 3100 IRD. The Jtag is a generic I bought from a guy but it came with no instructions as to what wires to solder to which pads on my IRD. The unit had a 10 wire cable with the following outputs for wires:
TCK
TDO
TMS
VDD
TDI
Vref
TRST
nRST
as well as 2 grounds.
I have searched thru the forums looking for a "map" as to where to solder what wire and have actually found 2 versions which actually contradict each other and therefore I come to this community for help. My IRD has eight pads in which I can solder to but I know from using my broken pogo Jtag that I only need five. the pictures I found dont show which way they are looking at the IRD from ...front or back so I cannot determine which is correct....any help would be greatly appreciated. thanks in advance for your time
Bluize