PDA

View Full Version : Store question for Mili, or Mods

Baby Jaguar
06-05-2006, 05:53 AM
I wanna buy a passive interface for some 311's. But I cant find any instructions on how to install them. Do they come with it? or how the heck do I install it? I have fucked up a couple of 311's already with trace cut repairs and shit, and looking at mili's pics, the interface stays in all the time. This is what I want, but I dont wanna buy something if it's not gunna come with a how to.

Please respond asap.

Thanks
mopar611
06-05-2006, 06:00 AM
I dont know if I am right..

I believe the s/c is already opened.. So the trace cuts should be repaired. So all you need is the pic to read it right?? So the pogo pins should be already glued down on the board so all you have to do is plug in the pic to it then read it with an iso..

That is my guess..

Mopar
Baby Jaguar
06-05-2006, 06:03 AM
I mean, if I want to use my own 311's. meaning I would need to know how to install the interface on my IRD, not one bought from Mili
mopar611
06-05-2006, 06:05 AM
Have you glitched into your 311 yet?? Or you want to know how to do it??

Just do a db9 pin.. Its better..JMO

Mopar
mopar611
06-05-2006, 06:07 AM
I mean, if I want to use my own 311's. meaning I would need to know how to install the interface on my IRD, not one bought from Mili


The pic I believe is not itself installed on the board.. It has the 5 pogo pins glued to the board so you can connect the pic to it..
stinkfist
06-05-2006, 06:53 AM
I believe there is a new how to on programming the 311 & 511. Can these intergrated cards be looped? I have being reading that some Rom 102 cards with certain blockers have been looping. Thanks:D :D
mopar611
06-05-2006, 07:14 AM
Oh ya, they can be looped just as easily..

I dont think the blocker itself loops the card. Its usually from glitching the card which results in a looped card. Maybe even writing the blocker could loop the card..

There was a blocker out the other day that would cause unknown provider. But not the same as being looped...

Mopar
Baby Jaguar
06-05-2006, 04:36 PM
can anyone elaborate on the Db9 connection? \

basically I keep fucking up the IRD's when I have to replace the pulled resistor, and trace cuts. so If I can find a way without having to keep soildering that would be great. I am hoping to find a way to soilder something on and leave it hooked up all the time.