rom 103 rev 380

[cvhu]

i have a 322 ird exsub , i have the s/c chip pulled out and wired to a old hu bootloader board , it pulls an atr with a loader and iso with all programs, i cant get it to dump or get the Intercept to load. any help would be great......thanks

[Crazy1_79]

what loader are you using? what do you have for ohm settings? which swithces are on, what flash, what program, need specifics bud.

[cvhu]

i am using a orange nexus set at 2.20 with different switch setting , 1-5, 2-5, just 1 and still nothing using final 103 FM Intercept fm, tried rom 103 dumper

[Crazy1_79]

I hope it has 4619 chips some do, some don't if it has 4619 turn pot to 200 ohms with the ohm meter set at 2000 ohms, if you have 4053 chips, set pot to 20 ohms on 2000 ohm setting. I am assuming you are saying 2.20 ohms it is really 2.2k or 2200 ohms. so you are way too high.

[pecker88]

had a rom103 rev 380 from a 322 ex-sub as well.

I had to wire chip directly to my loader to get it to unlock. I was using a self modded T-911 w/ 4619 chips.

Here are my settings:
70 ohms at 200 ohm setting

I would highly sugest using the public dumper script FIRST. You have to change the start adress to 3000, then 8000, then B000. Pay no attention to the error after the script dumps that portion of the .bin.

After you have a 18k rom103 image, then use the "final fm 103" script to install the intercept.

Fine tune your loader when your running the public dumper script. It is possible, but very hard to loop cam w/ this script. Then once it dumps the 3 different portions of the image, DO NOT tuch the settings then run the intercept script.

Running the dumper script first assures you that you will get a backup of the cam. Then if you by chance loop it installing the intercept, you still have the bk's and ird info to put on another cam to use in the 322. Have to use this method b/c we are unable to jtag cardless ird's and extract vital info.

good luck

[cvhu]

hey crazy1 thanks for the info, i meant my pot was at 220 ohms,with the 4053 chips, i moved it down to 200, and pecker88 i have bin following your posts on another site great job on getting yours running ,i have bin running the 103 dumper for hours with no results, i am stumped dunno what else to do, any more tips would be great.

thanks

[cvhu]

well just an update on my journey with my 103 rev 380 i let it run with rom dumper for about an hour and a half then the dreaded happened , no atr , i have checked all conections all good , so now i guess i have to wait til there is a way to jtag it , hopefully not long .