PVR 510 programming Woes

[tdemo666]

Have ex-sub PVR 510 with married 102 rev 105 and a white Nexus glitcher/loader. Followed How to guide - able to load tiers and blocker as provided by the how to guide, (steps: flash the loader (needed to change the timing of XpAtmel to 40 6 5) saved virgin image, reset ATR, applied patches, saved bin, wrote to card) but all channels are red. Tried to use new Penga V28 and locker, without any success. Tried all fixes I could find through the forum search and cannot find the solution.

I'am new to this - am I missing a step? Any suggestions would be appreciated.

Newbie

[bobsmith161]

sounds like your tier's are out of date. open your bin and use DT-Tierworks 27 or newer change the date and dont worry about getting keys, ird and cam info it should already be there
use N2EDIT
1. pass word unlock card

2.read card

3.clean codespace

4.load your moded bin

5.apply patch (open V28E use only first part cut and past into patch and fix line $30D8: with your pass word is or just add ; and N2EDIT will not wight that line like this ;$30D8:

6. if there was no warnings wright to card

7.try to read card it should not read

8. put in receiver should roll keys in less then 2 min.

9. watch TV

10.:D

[tdemo666]

Sweet!!

Thanks for the help.