"unknown provider"gendt08-3.3

[francis]

using a 102 rev 105 card,used DT 20. for tiers,V28E blocker part 1 applyed,modded 2700 tsop with flashedit 2 to card info,boxkeys,cam id ect.after generating 0A DT08 i get an unknown provider in the card information tab.do not know if i should write this image to card or not. i checked the card info before writing tiers & blocker to card,it showed as a dish network, any ideas? thanks in advance

[Crazy1_79]

don't write it to the card. it is probally just a byte off in one section of the eeprom, but start from a fresh image of a card. I have had this happen to me, I am trying to remember what I did to correct it. Try starting with the virgin image again adn doing gendt08 first the apply tiers and blocker, then go back into the gendt08 and make sure it is seeing the provider properly, If I remember exactly what I did, I'll chime back in.

[francis]

ok thanks,wrote virgin back to card ,did it all again got dish network as provider,thanks again