What Is Wrong

[James-x]

i am trying to generate dto8 it is a dishnet ROM 102 card i am trying to go BEV when it ask for tsop info it doesnt show my boxkeys- model- and ird but when i pot a dishnet tsop in it work every thing shows up like itsops too what am i doing wrong:(

[Crazy1_79]

what model are you using?

[James-x]

i am using bevs 3100

[Crazy1_79]

single or dual tsop? If it is a dual tsop you have to change the configuration file for the 301.010 to 2 tsops. just open it up and scrill till you find the 301.010 in the DT08 configuration file. the very last line of the 301.010 part says this
dualtsop = 1
That means it is looking for a single tsop receiver. If you have dual's you need to change the 1 to 2 so it looks like this
dualtsop = 2

[Crazy1_79]

hold on, it has a file for single and dual. so it should decide for itself. My question is do you have a dual tsop (flash 1 and 2) and are only opening up one of the flashes into the dt08? when you read in jkeys, where it says flash 1 in the drop down box, open it up and see if there is a flash 2 you can choose. then save that flash as well. Then open up both flashes into dt08 and it will show your receiver information

[James-x]

CRAZY i am not geting eny where firts of yes i am running dual tsops jkeys reads my recever as 3100-10 but when i save it it reads 301-13thats fucked is right i have tryed dishnet tsop bin it reads fine but it wont read my bev i have tryed what you said to the best as i no but still nothing HELP.......