ROM 102 rev. 107 What should I try 1st?

[bigjohn]

I have a ROM102 rev. 107 that I am ready to unlock. I have a white Nexus that I just received from mili that I have flashed with Newd13. Which unlocker should I try first? This is my first and only ROM102 so I don't want to make any mistakes.

[Crazy1_79]

rom10x_reader_writer is a good place to start.

[Crazy1_79]

I mean it is a good script to start with to unlock that card. it will probally get it done for you. sounded like I was pointing you to a how to guide in the first post.

[bigjohn]

Thanks Crazy1! I'll give it a shot.

[bigjohn]

Crazy1, do you mean the ROM10X_Unlocker?

I could not find a ROM10X_reader_writer.

Thanks!

[Crazy1_79]

that's probally it bigjohn, it uses newd13 and is good to rev 106 and rev 107 read the top of the script it will tell you if it is for 107.

[yordan40]

These card love to loop so you need to have care with. First of all ones you have you winexplorer running do not change the ohms of the pot if for some razon you need to change the ohms stop the script and start over. I had pop 2 102 rev 107 with 515 ohms on it, i am using a t911 with 4619 chips on it, newd13 and the script: ROM10X_reader_writer_unlocker. dip 2 on and 9v 300ma. Good luck..

[SSDA67]

Make sure to check your OHMS output Before trying to set card.Also make sure to have not much more than 9-Volts of Output on your Power.
SSDA67

[Crazy1_79]

yes, set ohms on pot BEFORE plugging power into glitcher, I usually do it before I connect the 9 pin cable too. can't check ohms with voltage running.

[dom615]

Help i have 2 bev sub that are rev 640 can i do somthing with them please help thanks? sory if im of line for asking this.

[SSDA67]

READ RULES..Your 1st post shouldn't be asking for a script help...There is plenty to read and figure out if you spend the time.