I have a problem with a blue nexus unlocker

[PCB2]

that after unlocking a ton of cards, it ran into it's first rev107 and puked out. When I plug the power supply in the light is bright but after a few seconds it slowly dims and goes out. My question is, Does anyone know what chip would cause this or is it even worth messing with and should I just get another one?

[traylehr]

Try getting your mulit meter & start checking, start w/ the pwr. rectifier. chip .
It kind of sounds like the pwr. chip is pooping out.

[Nagra1]

Could be a faulty power supply.....check the voltage

[PCB2]

My power supply works fine with my programmer but when I get a chance this weekend I'll check that out too. It's an adjustable power supply and I did notice when it first happened I had the voltage at 9 and then it errored out on trying to re-flash the atmel. I dropped it down to 6 volts and it flashed ok. It wouldn't glitch worth a crap at 6 volts so when I put it up to 9 it glitched for about a half hour and then puked out again.I'm assuming the power chip is closest to the power supply input so I'll check that 2nd and see what I get.