PDA

View Full Version : Digital lock 2.1 oddcircuits help

mrfleck
10-24-2003, 10:06 AM
I have a digital lock from oddcircuits that I am trying to wire and they have the incorrect instructions on the site. While I am waiting for help, thought I would post here and see if anyone can help me.

He has posted the same pic that most have for a 301.013 receiver showing a connection point for we#0 and we#1 unfortunately, the 2.1 only has a pad labeled we# no numbers after the w# and no second pad. Has anyone installed this lock and where did you attach the we# to on the board?

Thanks in advance,

Mike
PWA
10-26-2003, 01:55 AM
You can just attach it to any of the WE#. I use the one that is marked WE#1 and don't remove the resistor.

PWA
mrfleck
10-30-2003, 04:05 AM
Well I already removed the resistor....bummer... can I just connect both we# 1 and we#2 to the we# on the board and be ok without the resistor?

You can just attach it to any of the WE#. I use the one that is marked WE#1 and don't remove the resistor.

PWA
PWA
10-30-2003, 04:21 AM
Yes you can.
mrfleck
10-30-2003, 04:23 AM
Thanks,

It seems to have a problem. When in the lock position it just continually resets the box. I double checked the connections, but seems to have a problem. Has anyone seen this?

Yes you can.
PWA
10-30-2003, 04:26 AM
There was one batch that came out that had false trigger problems, just email them with it and the should replace it with a new "AR100".