Help Please 311

[vietlong2005]

Hi All,
Here I Have Is An Atmega Card.
Can Someone Help Me Point Out Where Is The Soldering Point For
1) Gnd
2) I/0
3) Vcc
4) Rst
5) Clk

On The Atmega Card To Do A 311 Reciever? I Have The Picture For Both Front And Back Of The Card. Please Tell Me Which Side To Solder Those Point. I Did Alot Of Reading But Still No Clue What So Ever. I Only Have One 311 Reciever With Rev281 To Do.
Thank You In Advance.

[fibrechunk]

Here is mine hope this helps.....I used hot air gun and took all chips off the other side.

http://pic20.picturetrail.com/VOL1456/5650671/11227712/163752903.jpg

[vietlong2005]

Whoa!
Great picture. Thank you so much. I've been waiting for this
God Bless:D

[Crazy1_79]

boy you are lucky I am feeling helpful today. here you go. if I am wrong. then move all conections down once spot. but I think I am right. It is hard to tell w/o having the card in my hands.

[Crazy1_79]

seem to be having a problem uploading pics. no wonder that picture is huge!! must of been trying to upload the same time I was. allright. as long as you got your answer

[vietlong2005]

Thank You All

[fibrechunk]

Crazy1_79 Sorry for the size but I used paint and the text was kind of small.:D

[vietlong2005]

one last question for fibrechuck
After removing all the chip from the other side of the atmega card. I then solder those 5 wires to those point of the atmega card. Then I solder those 5 wire from the atmega card to the 311 reciever ( cut trace ofcourse) I now then start glitching???
Thank you

[Crazy1_79]

no problem fibre. it let you post it so size is w/in limits. it is easy to see that is for sure. I was just commenting on the size. nice work there. did you successfully get that chip wired up to it?

[fibrechunk]

vietlong2005 That is correct. Although I don't know if you have to but I cut the traces on the back of the card right after the junction spots. You really don't have to but I didn't want any more trace then I had too. I would check your connections with a ohm meter though just to make sure there is no solder on the back side shorting something out. Here is a picture of the back side. ( I glitched with card and wires direct to board then after glitch I setup networking plug to program)

The chip is another 311 rev 283 that I couldn't get to glitch right away. So I took the chip off too try and glitch. Same results...So I tried pin one down on my unlocker.....loop city.....I guess I just got too impatient and tried to rush things. I just did another 311 rev 283 and let it run with nagramaster. It popped just took longer then cards.

http://pic20.picturetrail.com/VOL1456/5650671/11227712/165638236.jpg

[vietlong2005]

Thank you for all your help fibrechunk.