haven't seen this addressed anywhere

[jskey]

102 rev 103
t911 self mod blueboard
25ohm rheostat
newd13 flash
dips 3 on
intercept script in winex 5.0

+--+--+-no resp.

then several lines(in red) of "Sc Read: time out reading from card 27 bytes requested 14 bytes read....continuing script +-+-+-+-repeats for awhile then goes back to just +-+-+-+-+-

Ive seen it get up to 27 requested 26 bytes read

is this part of the glitch process or is there a setting I need to change in winex 5.0?

Ive already looped one card following someone post to try dip 1 on and certain changes in the user configurables. Dont want to loop the only other 102 I have

anybody else have this?

[foxx1600]

ya never use dip one except to program the atmel.. i have best luck useing switch 3 or switch 2 usualy use a mix of .9 and i get a more random patten more like +---------++--+--------------+--+---+ ect with maybe a reset every few lines
I use explorer settings
data and reset baud 115200,parity none, rec timeout 1000, byte and reset delays 100, stop bits 1,direct, and check flush recive buffer before writes.
advanced device reset no atr, DTR low RTS high and toggle set to RTS

and on 102s i use a script simply named "new works" posted on most sights tweaked for t911 works well on rev 103 - 105
good luck

[VOLTRON]

102 rev 103
t911 self mod blueboard
25ohm rheostat
newd13 flash
dips 3 on
intercept script in winex 5.0

+--+--+-no resp.

then several lines(in red) of "Sc Read: time out reading from card 27 bytes requested 14 bytes read....continuing script +-+-+-+-repeats for awhile then goes back to just +-+-+-+-+-

Ive seen it get up to 27 requested 26 bytes read

is this part of the glitch process or is there a setting I need to change in winex 5.0?

Ive already looped one card following someone post to try dip 1 on and certain changes in the user configurables. Dont want to loop the only other 102 I have

anybody else have this?
If you only have a 25 ohm rheostat it will loop the card on it's own...

You want dips 1&2 on and the rest off.
Start with something around 60 - 100 ohms
Then work your way up from that..(Note its not advisable to adjust ohms with script running)
If your getting a good mix of plus and minus then let it run,i had one take around 40 minutes.

[skinerd]

My modded T911 like sw 1 on only, and if you are getting +--+--+-no resp+--+--+-no resp+--+--+-no resp+--+--+-no resp, it should open shortly...