ROM102-REV109for0001-V28G-BLOCKER-sk! Can't get back in! Help!

[Bubba Lewey]

I used the software ROM102-REV109for0001-V28G-BLOCKER-sk in the downloads section with my own password and have not been able to get back into my card! Is there a way?

[NICKY__6]

open the blocker and look at the password line make sure u changed it right

also did u read the card after u wrote make sure blocker took

[Bubba Lewey]

I tried to read the card to make sure it took after writing and was unable to read it. Run it in my receiver and every channel was blacked out except preview channels so tried to get back in with the password with no luck! I will double check the password later today and get back.

[NICKY__6]

FIRST
if u read it before it wen in ird and it was locked thats good means blocker worked your just using wrong password

SECOND
all channels were black but preview casekeys have to roll can take 20 min sometimes
leave on ch 101

THIRD
if after 20 min ch dont roll maybey the ird firmware not up to date check that

then open the file u wrote in n2edit or nagraaster apply the blocker like u did if all in one file just open file
and go to password line and check what it is

if it is the deadbeeffood one

make sure u enter ZEROS not the letter o or pass wont work

the password useually is
$9878:AABBCCDDAABBCCDD
;

[NICKY__6]

also that blocker if used seperate was suppose to be put in 2 steps
if u applied all at once u messed up

try 000000000000 or 3333333 due to corruption

[harrybuckman]

try both n2edit and nagramaster. Sometimes they both give a error but the card is unlocked

[Bubba Lewey]

I have copied and paste straight from me blocker with both the original and my own password with no luck! I have even gone as far as to find other locations where it might be and tried those as well. I have also tried 0000… and 3333… FFFF… and other combinations and have had no such luck. I see where someone has had the same problem and used this file (Glitch A0FF and Reset Bugtable to write patch at 9BC0-Feb 23 2006.xvb) to get in but I have searched the site and have been unable to locate it. If someone knows where it is, let me know please! Thanks

[Bubba Lewey]

Well it's a done deal and this is what I did to repair it! I should have tried a read between these but I can't say that I did. I figured one of the scripts would have said when it did it's job but I guess not. I ran: ROM102_ND13_A0FF-INTERCEPT-autoVCC_20_Smart.xvb for a while and then: Bug Resetter for a while and then: Nagra Master 2.1.1.0 with its new added unlocking glitch features and then tried password unlocking in Nagra Master 2.1.1.0 with my original password, and it let me in! Nice progs to you guys that help make them! Thanks a bunch!