311 Ex subbed starting from scratch.

[ahmar03]

:rolleyes: ...... Ahmar03 next mission is to learn how to program the 311 ex subbed recs. I got the Passive interface card today.. Does anyone have the proper diagram and instructions on how to attach this interface card? My card isn't labeled and doesn't show which connection goes where. So if any who has completed this task please help becuase it be greatly appreciateed the help. Thanks.

Basically starting from the begginng. Read the instructions provided couldn't see the proper connections. Im looking for one with in depth detail on what and where to connect. So please help thanks,
Ahmar

[bbluver]

The 3 RS...Read-Read-Read. oh--(and look in the files)...the info is here!
(How to open your 311.doc)

Milli is good, Milli is wise!

[hardin2469]

I just did a search for the doc. that you were talking about and this is the only thread that came back with that string in it. If you or anyone else could post a link to it I would be greatful as well. I just received a 311 and I just ordered the passive interface and I wanna get this thing goin. Thx

[lightning0009]

http://www.dssftp.com/forum/showthread.php?t=59761

http://www.dssftp.com/forum/showthread.php?t=58566&highlight=311

http://www.dssftp.com/forum/showpost.php?p=333516&postcount=21

This is the how you hook up with millis passive interface cards to 311.

It's the same, but it's not installed on the ird board and you will need to unlock the cam before being able to read and write to it. To do it the way I do it, you need to cut one trace and move three little resistors out of the way to glitch and unlock the card with your modded unlooper, then you have to repair the cut trace with a jumper wire and solder the three resistors back in. Here is the pic of how I do it.
http://www.dssftp.com/forum/showpost...6&postcount=21
The interface card that milli sells header connections at the end of the ribbon cable are when you are holding it in front of you are left to right Ground, I/0 or data, VCC, Clock, Reset. Now the ribbon cable is to long to let you glitch so best to hook real short wires right to your unlocker and then after it's unlocked then put in the header or you can put another female header thing on the ribbon cable but real close to the interface card and use it for unlocking and reading and writing also.
Attached Images

I had to remove three little resistors. I was able to heat them up and push one side away from it's solder pad so it wasn't making contact. After I unlocked the card and programmed it I put the resistors back and I then used a little piece of wire to jumper from where I had soldered the vcc line to the resistor right below where I made my only cut. That basically repaired the cut.

[genehackman]

I got a 311 with a rev 284 - I cant glitch into but get an ATR - could wire length be my problem?

Have you ever glitched a 284 - which proggies, scripts, pot and other settings?

[bbluver]

Glitched 2 311s with ReblesurfOmniunlocker and T911 with 4619 chips.
Pot was replaced with a 49ohm resistor and a direct connect from the loader to the 311 cam wires less than 4 inches...