Need help with creating Blocker for BEV Rom103 rev.3C1

[gpaint]

Hi all,

Great site! I'm just getting into BEV & DN from back in the old hu card days. I'm an old fart just wanting to learn and have some fun testing.

Well, I've managed (through a lot of reading) to do a rom dump and glitch into the embedded cam (which I removed) from my BEV 9200. I've saved the rom103 bin several times. I've mounted my BGA chip on a pcb card and I also activated the external cardslot, so I can use it in the future with rom103 plastic.

I am not a coder, that I will admit. Is there a way or can someone help me build a blocker for my rom103? Also, can I use BEV-Tierworks to open all the tiers? I tried it out and it seemed to change and add the right information.

Your help would be greatly appreciated :)

[helpless5]

i think i saw a rom103 blocker in vipdownloads
it should have directions with it

[gpaint]

Unfortunately it's for the Dish 942 and not the Bell 9200 :(

I need a coder to mod it for the Bell 9200's rom103.
i think i saw a rom103 blocker in vipdownloads
it should have directions with it

[shark]

Hey Gpaint...do you want BEV or DN. The 9200 is supposed to be able to be changed to the 942. I have a 942 and I'm looking to do basically what you just did (I was hoping I didn't need to remove the chip) for my receiver. Can you point me in the right direction to do some reading...is there a hard drive complication like on other PVR's or do you just watch TV if you can hack the rom chip?