Stupid Question

[Hawkeye203]

Ok Guys am am very new to plastic and have a bumb question. I bought an open 102 from a friend and since i did not have an ISO at the time they programed the card for me. Now I have the tools and have to update the keys. I know I have to unlock the card with the PW in N2Edit and then read the card , change the keys and save the image. I belive I then clean the card and write the new saved image to the card. My big question is will the blocker relock itself when written to the card or do I have to do it in N2edit. I Know I can check by trying to read the card but I want to make sure the PW does not change on me or someting stupid that locks me out the card. By the way I belive he used Pengas blocker if that helps.

Anyway thanks in advance for helping an old AVR-x/Magic man learn some new tricks, hopefully with minimal damage to the wallet. Thanks again.

Hawk

[bobsmith161]

once you pass word unlock it. it's unlocked.. till you ether use a relock or just repatch the blocker. note if you are going to repatch the blocker you should clean code space after reading card. this will set the card read to rev103 and remove the old blocker code. then i would say it's safe to repatch the blocker. always test the blocker...try to read card it should fail.

[Hawkeye203]

Thanks for the info man. Away we go again for now!!

Hawk

[Texas Trophy]

After you unlock it then read it. Clean the codespace save the image and write back to card. Then open the cleaned saved image and patch your blocker and write to card. Read card, it should fail.