Virgin Rom 103 at rev 300. What do I do?

[Rocko7]

I've modded a miko3 and I've got an iso programmer. What do I need to do. When I read the card in Nagra 5.1 it gives me the rom and rev numbers but tells me to install a NagraEdit compliant interceptor. My modded miko has a 2.2k resistor. Do I need to change it to a pot or dif resistor? What flash (I'm using Newd13 currently) and what if any glitching script should be used?
Thanks
R.

[BiggerBear]

Rocko7 -
Did you get your Rom103 going?
I am getting one and want to try to Unlock it.

[Rocko7]

No and I think I killed it. I swapped out the older chips on my mkiii with 4619s and all was fine when I started the script. It rec the card and rev and then just went on forever and I stopped it and then when I tried the script again it did not rec. it and just kept giving me errors. So I might just buy a rom102 off ebay. In any case I would never have tried it out in my 921 as even if I got into the card I would not use it cause Id be affraid of having a very large paper weight down the road if something came down the line. Not like a 301 or 501 with jtag. And from what I've read and whats on the card its only good on a 721 or 921. Good luck.