where to take readings of pot

[jaicos]

Hi, would somebody tell me where to take the resistance readings ...?:confused:

[mtmt1us]

Hi, would somebody tell me where to take the resistance readings ...?:confused:
You did not say what unlocker you have.On my mikobu n2 you take the case off and probe the 2 solder points on the side of board opposite the pot.Do this with the unit unplugged from power and pc.I set mine to 1600 ohms for cards,less for 311 chips though.Good luck.

[smilingjack]

Any place where the power comes in to the pot and goes of the the pot.

Lever it un-hooked and find the wires and tun it around and the meter will change set it to where you want it and hook it up.

[NICKY__6]

like so

http://img159.imageshack.us/img159/9272/metersetupuv7.png

[smilingjack]

That a organe nexus
The pot that cone on it sits on the font where the two wires (top pic) are.

many of them you will have to get inside to get to, find the pot and accede to the wires their

[udntcme]

like so
http://img159.imageshack.us/img159/9272/metersetupuv7.png

HeHeHe...LOL...just make sure power is off and touch or connect lead's to the leg's connecting your "POT"...hehehe...all the best...!!!

[jaicos]

Thanks to you all for the information

[redwingfan]

You did not say what unlocker you have.On my mikobu n2 you take the case off and probe the 2 solder points on the side of board opposite the pot.Do this with the unit unplugged from power and pc.I set mine to 1600 ohms for cards,less for 311 chips though.Good luck. This is the one I have! What 2 points are you talking about?

[smilingjack]

pick two, hook a meter two them

one turn the screw:D

if you have the right one,

the meter will wiggle:)

if you don't have the right ones the meter will NOT wiggle :(