DP921 HDTV w/ rom103 card @ Mili's store

[kyn2000]

Are there any instrutions of how to program that DP 921 receiver showing in the store? .....Just like the DP811 or 311 have.
would appreciated if anyone can point me to.
thanks.

[Saturn055]

Hi, I bought a 921 receiver from Mili , received it yesterday and programmed it in less than 10 minutes .
Here's what I did:

1) I read the card using NagraEdit 5.2 and saved the card image twicwe (I named it different both times), named them "921 Original" and my "Best 103 Bin", I put them both in the "My Documents folder"
I used DT-Tierworks V26.7 to create a Bin with my tiers, I used one of the card images I had saved, ("Best103 Bin"),

A)I Organized and wipped tiers
B)I obtained the latest Keys and I wrote them right where the Key on the top of the box is.
C)I changed the timezone to match mine (I left the remap alone)
D)I modified the BIN File once again using (Best103 BIN)
E)I Set the PPV tiers

2)I read the card once again using NagraEdit 5.2 , opened the card image and used the Bin I had Modified.

3)I then (THIS IS VERY IMPORTANT)opened Patch Editor on NagraEdit 5.2

4)I then patched The "ROM103-REV309 for 0001-V3L Blocker (located in the file section of this site)

5) I made sure to change the password !!!

6) I then did a Test Patch , Run Patch and then wrote to the card !!!!!

Mili as you can see I did not keep it a secret.
Even though the 921 receiver is costly, my 921 ROLLS ROICE IS HUMMING !!!!

MILI YOU ARE THE BEST !!!!

[Saturn055]

The 103 card was opened and very easy to program.

[kyn2000]

Thank you for your help Saturn055. Apreciated.
I am now doing some homework about the cam id part on DT-works and on the blocker. What Info do i have to enter there?
Also when copying from the blocker to the patch in NagraEdit 5.2, I copy from the beginning but at the end the blocker it says....
; BEGIN DATA AREA $A700
; ADD YOUR DATA AREA HERE
so what do I enter there.....
thanks

[Saturn055]

1) you do NOT enter anything for the cam id in DT-Tierworks.
This unit is an EX SUB and the card already has the Cam Id and Box Keys.
All you have to do is use one of the card images you saved, do you remember that I told you to save the card image twice and name them different things?
2)For the Blocker all you have to do is just change the password to whatever you want, then test the patch and run it .
You will first load your card image in NagraEdit 5.2 (the one you created in DT-Tierworks), then do the Blocker thing (change the PASSWORD and take note of the changed Password) , then you will write to the card, please try reading the card to make sure is locked
If you follow every step you will be watching TV in no time.

Regards.