Bev Setup

[skamrodgers]

I am setting Bev up as a single to go along with my 110 /119.. it is on port 3.. the problem is when you check the 91 it shows 80% signal and 98% quality but they are flashing off and on constantly and the bars are in red? any idea what is going on..i have changed every setting in there but i know the correct port and transponder.. never seen it flash the bars off and on constantly and still stay red when signal and quality show a high percent? it will not find any channels when scanned cause even though it shows a high percent it is still in the red? any ideas? thanks

[conardh]

I am setting Bev up as a single to go along with my 110 /119.. it is on port 3.. the problem is when you check the 91 it shows 80% signal and 98% quality but they are flashing off and on constantly and the bars are in red? any idea what is going on..i have changed every setting in there but i know the correct port and transponder.. never seen it flash the bars off and on constantly and still stay red when signal and quality show a high percent? it will not find any channels when scanned cause even though it shows a high percent it is still in the red? any ideas? thanks

Seen the red flashin' before, for me it was a bad connection at the switch. Has to be somewhere between the switch and the lnb (including a bad lnb) Got to be green to work. I used a voltmeter to verify voltage 13 to 18 VDC on the center conductor at the lnb. Found the center conductor of the cable was too short to make a connection. It could be as simple as that.