rom 102 chip card question

[lennstrom14]

i am following up to a question that i asked mili about regarding new chip cards..are they open and ready to go in a coolsat 5000 --mili said some have to be auxed in programmer..if i have c/s with updated bin to read and prog cards is this all i need or do i need to use programmer...when new ecm comes should this be out of c/r or will it update like a 102 card does ..will this type of chip card get married to a receiver...can i test it in 2 c/s receivers that i have ...thanks

[fubr]

moved to the FTA section since it is asking FTA related question.

I do not know the answer or I would have went ahead and answered you while I was here.
I do know it acts just like a rom 102 card I have no clue about the AUX-ing deal

[madscientist]

i am following up to a question that i asked mili about regarding new chip cards..are they open and ready to go in a coolsat 5000 --mili said some have to be auxed in programmer..if i have c/s with updated bin to read and prog cards is this all i need or do i need to use programmer...when new ecm comes should this be out of c/r or will it update like a 102 card does ..will this type of chip card get married to a receiver...can i test it in 2 c/s receivers that i have ...thanks
If the chip card is unlocked, then all you need is one of the latest bins 127 or 128, and you can AUX the card in the Coolsat cardreader. After installing the cardreader, you will see a new menu choice at the bottom called "CA" select CA and then move to the right where there will be a "Slot 1" insert your unlocked card and the "slot 1" will change to "Nagravision" then with the remote punch in 8282, and another window will appear with a button, you push OK on the remote, and a progress line will move from left to right, if it goes all the way to the right to 100% you have successfully AUXed the card, press the Exit button on remote, and as soon as keys roll you will be watching TV (of course at this writing the ROM card is NOT needed, but this is written as if you did need it). If when AUXing the card the progress bar only goes to 50%, that usually means that the card is NOT unlocked, but try removing and re-inserting card and try again. If it still only goes to 50% then you will need to get the card unlocked.
As far as security to the card is concerned, most folks say the card is perfectly safe in the Coolsat, I know it will not update to a later revision in the card reader and there is no such thing as married receivers and cards in the Coolsat.