Bev Question

[skamrodgers]

i am having an issue getting bev setup..i have a dp 500 for my 119 /110 and using the 4 port sw.. they work great..i have a single setup for my bev on port 3.. i get 80% signal but stays in the red bars not green..and my quality stays on 95% in red and flashed continuosly... will not come in green..i have it setup for single on 11250 and 12224.. is this correct for bev? i have tried several options and no matter what it stays red and flashes on quality... i have switched the lnb with another and the cable to the port 3 and lnb..still same thing.. any suggestions? thanks

[jumbo768]

i am having an issue getting bev setup..i have a dp 500 for my 119 /110 and using the 4 port sw.. they work great..i have a single setup for my bev on port 3.. i get 80% signal but stays in the red bars not green..and my quality stays on 95% in red and flashed continuosly... will not come in green..i have it setup for single on 11250 and 12224.. is this correct for bev? i have tried several options and no matter what it stays red and flashes on quality... i have switched the lnb with another and the cable to the port 3 and lnb..still same thing.. any suggestions? thanks

If your using a dish pro lnb then thats the problem, my understanding is b3v only use the legacy lnbs...jmo

[skamrodgers]

i am only using the DP on the 110 / 119.. the bev is on a separate sat a single legacy...not using same sat..just same switch...it is on port 3... that shouldnt matter about the 110/119 on DP should it?

[jumbo768]

i am only using the DP on the 110 / 119.. the bev is on a separate sat a single legacy...not using same sat..just same switch...it is on port 3... that shouldnt matter about the 110/119 on DP should it?

test bev by itself and if your going through a dp34 then it will not work. Hook the b3v direct to sat wire and do a switch test just so the sat locks to signal. If your using just 91 sat then doing switch test will lock it in, i m running all leagacies here for dn and b3v good luck