White Nexus Unlocker case

[coolman2]

I just got the White Nexus Unlocker case in the mail. I recieved the unlocker itself about a month ago. My question is how do I install the unlocker circuit board into the white case? When I tried it, the white case does not want to close shut.

Thanks,

[Cristian]

Take a pic of were it doesnt close good maybe we can see what its going on with it or what you did wrong..........

[mili]

You will have to file the case a bit to fit over the Atmel sorry.

mili

[JT]

...yep, just file down the back, right corner of the top of the cover next to where it would normally set on the board. Just enough so the back end of the long skinny chip (the Atmel) doesn't interfere with the cover.

[coolman2]

I used a nibbler to cut out a slot for the Atmel chip. I now have it installed. However, the included screws is not your standard philips screw.

Thanks,

[JT]

So get some square head screw bits. Might want to pick up a set of torq heads too so you'll have them when you need them.