Lost Remote control function after ecm

[mrfleck]

I got hit today (apparently something goofy in my tiers, new at this and have not quite figured out the ppv string stuff) I reflashed the tsop and eeprom and now the remote control does not work at all. Channels are back, just no remote. I reflashed again to make sure something did not go wrong there, but no luck. Has anyone heard of this? Any suggestions?

Thanks,

[pyle]

I got hit today (apparently something goofy in my tiers, new at this and have not quite figured out the ppv string stuff) I reflashed the tsop and eeprom and now the remote control does not work at all. Channels are back, just no remote. I reflashed again to make sure something did not go wrong there, but no luck. Has anyone heard of this? Any suggestions?

Thanks, it could be that some models loose the remote address that you programmed in there after ecm. it goes back to 1 but the remote stays the same. if this the case pull the card out and wait for sys. info screen to come up. than point the remote and hit record. if the address changes than that's the problem. hope this helps

[mrfleck]

That was it. Thanks a bunch everything works now.

it could be that some models loose the remote address that you programmed in there after ecm. it goes back to 1 but the remote stays the same. if this the case pull the card out and wait for sys. info screen to come up. than point the remote and hit record. if the address changes than that's the problem. hope this helps