102 won't fully write.....

[gourmetboy]

hi!, I have 2 102 cards, both had been programed and been at 109 rev.now i changed one about a week ago to the new rev 10B, i had no problems with the fisrt one, i had the new bin with the blocker in it(102 rev 10B) .but now that i wanted to program the second one ( for my cousin) and i opened it with my password, .....now i usually read the card afew times, in nagramaster, make sure it reads, then i write a clean 102 rev 103 image using nagaramaster..it ususally writes, but this time wont let me read.....it reads , card migth be loocked..?" but the thing is tha if i use nagaredit 5 , it reads, so i wrote the bin i put to the other card but it won't write in the blocker space....it supossed to lock itself if reread in nagraedit 5...but it reads the card, it says,102 rev 10B............. card read succesfully". and i read the eeprom and i noticed that the blocker space is empty.....how could this happen??? i had rewrote the 102 clean image using nagaraedit 5 and it writes but not complitelly but is reads the card. it says " 102 rev 103 ..........card read succesfully'. do you guys think i should use nagramaster and unlock the card again using my modded loader? any help would be appreciated.

[gwabitz]

Are you using an ISO or loader? Since you are using Nagramaster, I would guess a loader. Have you ever cleaned code space before? Depending on what blocker you are using, you have to make sure your BIN matches the blocker you're using.
I know with the codespace blockers you have to make sure they are the same.
Did you apply a patch? You have to give a bit more info to help you.

[gourmetboy]

i got it......i don'tknow what happened, i asuumed my card got softlooped,but the weird thing is that i was able to write back and foward from 102 rev10B to 102 rev 103,but it was giving me a message that the writing was failing. after i wrote both bins, i checeked on the blocker space there was nothing, so i put my card into my loader to get unlocked for afew hours........meanwhile,i was doing some search, finally i read a post which said that after unlockin the card, do a clean code space,,,,so i did,even though i could not read the card on nagramaster,(1.5 with iso)i just click on code space. after that still no luck, so i opened naraedit 5 and read the card,it read fine, so i load the latest bin(rev 10B) and this time it wrote fine. so i reread the card and this time i couldnot read. i assumed blocker was installed,so i put card in recevier and watch tv............but still don't know what happened.......lucky i did not lopped my card...i destroyed my first one a few months ago..... thanks anyways "gwabitz"

[gwabitz]

Glad to hear you're up and running. There is nothing more frustrating than thinking you've screwed up a card. Sometimes programs will say write failed, but it actually wrote. Texas Trophy has a good "how to" on writing to cards correctly. He also has other how to's. I like them because they are easy to understand, and to the point. They are all very well done. Check the stickies.