card just got locked.. how ?

[DrSatMan]

With the suggesstions of mili, I cleaned my card using romcode... read card in nagramaster - change key from 11 to 3D.. then saved and applied patch
finally, I applied romcode and programmed it

and now.. my card is dead...

romcode says "No Card Detected"
nagramaster says ' NO ATR: Locked ????"

What can I do ???
This is the only card I have and I dont have another..

[DrSatMan]

Nevermind..

Somehow, I just poped the card back in atr was able to reset

so, it's working now

[felicia]

On the same subject of locked cards I just bought one of the DP311 receiver with interface and Unlocked Integrated ROM102 card (https://dssftp.com/xcart/product.php?productid=54&cat=0&page=1)
from mili and when I run it through romcode it says card is stream or dealer locked. I have not put it in the stream yet or even plugged it in. I followed the how to instructions with the N2Edit but when I hit reset card it says ATR: error. Anyone know whats going on?

[felicia]

I should add that the card reads fine with romcode as well as with N2Edit 5.0. It is the beta 7 that gives the ATR: error.

[foxx1600]

try cleaning contacts lightly with a eraser little finger oil or dirt form inserting card will make it loose conn

[mruk69]

Read this
hxxp://www.satjunction.com/forum/romcode-premium-dish-loader/23493-dealer-locked-stream.html

[felicia]

Thanks guys. I will follow up on you suggestions and post again.

[felicia]

nothing is working. I tried the link you gave mruck69 and tried all their suggestions but nothing worked. Still says dealer or streamed locked. Like i said i have not had it in the stream or even plugged in yet. In mili's store it says it is supposed to be unlocked when you buy it.