Just bought the darn thing

[bule666]

yesterday. diseqc switch, 4x1, and I got it hooked up to a old drk tv sat with 2 dual lnbs, only using it for 91, and 82. I get good signal on both suckers, when I scan for tps, I only get about 699 channels , and I am missing all of 82 hd channels. I done scan to 82 with out the switch , and can get all coresponding channels. My settings are as follows:commited lnb 1, and 2 with both on 0,0,1250, etc.. duh, who am i kidding freaking bad switch.

[bule666]

well, thanks everyone for helping, but I found my problem. I was using cheap dms diseqc switch, which after reading a crap load found out that those dont work well, with twinhans. Credit goes out to the young fellow who posted that pic, from someother website. What I did is I stopped at ratshack after work and bought 2 ceramic capacitors @ .0047uf 500v, solder the suckers to a resistor and diode, to stop the noise, problems, and now I am able to switch both birds. According to the pic you need a 25v but ratshack dont carry those, and the 500v will do the job. I hope this helps someone, if your having the same problems.