PDA

View Full Version : ISO Programmer Question

ratzeputz
10-07-2006, 09:23 PM
OK, heres the situation

I just bought a DP311 receiver with a ROM102 chip on a wafer board. It worked for about 2 weeks until 2 days ago

I have 2 programmers, a Miikobu III and an ISO one that looks exactly like this:

http://www.dssfix.com/Home/Products/Dan_Programmer.gif

I don't know how to program the card, I have only ever used the atmega. Can someone please help me? At least point me in the right direction?

I tried to flash both loader it says trying to flash loader with nd13

hex files loaded
initializing
initialized
syncing
failed:could not find active atmel!
complete


then when I try to unlock card it says need to run nd13

My question is, do I have the right programmer?

Once I get it going what is the next step?

Thanks
mopar611
10-08-2006, 12:46 AM
You are not even close here bud...

You are trying to glitch back into your card.. No need. Unless you locked yourself
out of it..

Using your iso pictured, and using Nagramaster, use the password function in tools and unlock your blocker.. Then save your image before you do anythingelse so you dont screw yourself.. You need it.. After you do that, then scroll
down to the bottom and change your keys to whatever they are now. Then
write the image back to your card.. Then look at everything to make sure
it wrote fine. Then lock it..

Mopar
ratzeputz
10-08-2006, 07:07 PM
Thanks for the response mopar611.

I tried to use the password function but it quickly shows FF then "This does not appear to be a valid ATR". Finally a dialog pops up and says "You need ND13 atmel version to run this program"

I have the correct password I think. I'm not convinced I have the right firmware on the iso programmer.
fubr
10-08-2006, 07:51 PM
live links are contagious
mightymoose
10-08-2006, 08:02 PM
a "programmer" does not have an atmel chip, a loader does. You cant flash the programmer. It is only used once your card is already unlocked.
mopar611
10-09-2006, 02:05 AM
Thanks for the response mopar611.

I tried to use the password function but it quickly shows FF then "This does not appear to be a valid ATR". Finally a dialog pops up and says "You need ND13 atmel version to run this program"

I have the correct password I think. I'm not convinced I have the right firmware on the iso programmer.


There is NO firmware on a ISO period..

You do NOT use ND13 ..

Like I said above, you are not even close..

Go to the word CARD in Nagramaster.. And click on password unlock.. This
is what you need to do....

Do NOT click on tools and unlock card.. This is what will give you ND13 error..
This is the glitching program here.. You are NOT glitching..

If you still are getting that FFF or no atr, Nagramaster is not communicating
with your iso. So your setting may be wrong or you card contacts dirty,
cable not hooked up, iso not plugged in, etc.etc...

Mopar