Changed out 4053's with 4619's

[baruskie]

I have a Mik III Rev C that I have been using to unlock rom102 rev 103’s and 105’s and haven’t had any problems at all. I changed out the 4053’s with 4619’s and tried to unlock a rom102 rev107 and looped it on the first try in 20 seconds. This is the first card that I have looped since the rom3 days. Did I just have some bad luck or are the higher revs just really touchy and easy to loop. Has anyone else run into this problem when replacing the 4053’s?

[ge2]

So it is possible to open rev103 with old Mik III without doing any mod? What software did you flash it to open rev103?

[baruskie]

You do have to mod the mik III

search for mikobu iii mod and you will find out how.

My Mik III is a M6.2 and is modded and I have unlocked up to rev 105 with out any problems.

[Zim]

higher revs are easy to loop if the resistance is not set right ...I my self have looped a couple 108's and 107's ......just the other day I was trying to unlock a 107 at @ 200 ohms and was getting a weird responce so I tried higher ohms @ 500-700 and was getting weirder then I dropped to @ 50-100 and was on its way then started actin funny again so I set it back to @ 200-300 and it looped with in a couple secs......I usually am able to unlock with no probs but every now and then get a stubborn card and sometimes loop em....good luck on your next one......also make sure the chips are installed correctly this may be a prob as well

[sttran]

Can I just mod the Mikobu III M6.2 and don't change the chip to 4619. and program + unlock the 102 card with rev 103 or Rrev 105? thank!:D

[traylehr]

I too use the mik lll c to do my cards & it's excellent on lower rev's, if i were to do an 4619 upgrade i'd piggyback them so you could use eather / or if you know what i mean.

[Zim]

don't think piggy back is good idea...4619 will also do 103 and 105.....all it does is give you faster glitching.....

[hector100]

Can I just mod the Mikobu III M6.2 and don't change the chip to 4619. and program + unlock the 102 card with Rev 103 or Rev 105? thank!:D yes you can. I've been unlocking and programing rev 103 and 105 with my MIK III 6.2 rev C green case with any problems pot set @ 2.19K. BTW i just ordered a couple sets of those 4619's to replace the 4053's so, experts: can I unlock rev 106 and 107 once moded? thanks.