t911 mod question

[gsdluvr]

Got a t911 clone that I want to mod. I've looked at everything I can find in these forums on it. I have found a couple that look like mine as far as the board layout etc..Mine looks alot like a blue board and figured I would go with a mod for that.. Problem is the 2 I have found have had 2 different mods done to them. I want to know which one I should go with for my particular loader. I also have not been able to figure out if any of the pins have been lifted and wires soldered to or if the wire just gets soldered to it while still in place. I have a couple pics I will post of my loader. It came in a dark blue case..Bought it a while back when H/hu was the thing. I would appreciate any help you can give this newbie. I don't mind reading so even if I could get a link or something that would be cool.

[traylehr]

look under sdsaw76 post - (please help)--do it in this thread with the search botton , i posted some pic's that will help you , this won't let me post them agin here .

[gsdluvr]

Thanks Traylehr, I found the pics and the 2 named my %20t911 look identical to my loader. I have a couple more questions though I hope you can answer for me. On the top side, the wires at chips u2 and u7, are they soldered to the pin in place or are the pins lifted? Also, on the bottom side it is kind of dark and hard to see. Do you know where I can get a clearer pic of that? It looks like there are some traces cut and I want to make sure I cut the right ones and I want to make sure I'm soldering to the proper locations. One last question, Which wires go to the trimmer and which ones go to the switch I have to add for the glitch? The top pic shows 2 sets of wires going off the edge of the board and I assume that one set goes to the trimmer and the other to the switch? Thanks again for your information. It is greatly appreciated.