White Nexus

[manofwarsaw]

I purchased a White Nexus from this site. Doe`s anybody know how to change the pot to 200 ohms? Thanks

[Ohms]

It's really easy. If you look at the power connector, there is a little gray variable resister right next to it that you adjust with a small screwdriver.
To measure the ohms, unplug the power from the unit and connect an ohm meter to the two little solder pads just between the gray variable resister and the power supply connector.
The pot is SUPER touchy.
Now what I did, was solder wires to the two solder pads, and run them inside the unit to to screws that I put through the top of the case. This gives me a very easy way to connect my ohm meter when needed.
To tell you the truth though, since I set it to 700 ohms, I have not needed to change it. This has worked for everything I have tried.
See attached picture

Also notice my $2.99 Harbor Freight special ohm meter.....